Resetting The Motor Stops On A Sunsetter Awning

Limit how often you open and close the awning as overuse on a hot day could cause the motor to cut out.

Resetting the motor stops on a sunsetter awning.

Step 1 push the middle button on the remote control and unplug the awning s power cord from the electrical outlet. A very specific problem but maybe i m not the only one. If the remote control stops working with the awning it needs to be reset. A for 5 seconds until the motor jogs then release.

Resetting the limit push buttons of the sunsetter motor awnings with motors installed on the right as you face the house appendix b 2. These push buttons will be on top of. Motor to lose stop position settings which will require resetting the motor stop positions. From a stepladder locate the limit push buttons on the motor.

The motor could be overheating. Unplug the power cord from the electrical outlet on the wall. The reset process appears convoluted but when followed closely it will reconnect the remote control with the motor control unit. A jog is a short back and forth movement of the motor.

When the motor stops press and holdthe programming button on the back of the remote transmitter see fig. Plug the awning back in if necessary and try using the awning again. Remove four 4 2 phillips screws. If you need to reset the motor stop position settings refer to the enclosed instructions on how to reset the motor stops.

Press the neutral stop button on the remote.