Replace Broken Siding House

Above the bottom edge.

Replace broken siding house.

Here s how to repair damaged clapboards also known as bevel or lap siding. The best way to get a replacement piece is to take the broken piece to vinyl siding distributors in your area and find the closest match. Push the new piece into the nailing strip of the course below. Over time however seals can weaken so it s important that you consistently check your siding s seal and replace or recaulk any damaged areas.

Take the replacement board fit it in place image 2 and nail it in with a hammer using galvanized nails. It ll better match the house than brand new siding. Replace siding by working from the bottom up you might need a helper here. Nail straight down on the replacement board in order to hit studs.

Here s how to replace damaged siding on a house in four easy steps. A quality siding job is well sealed otherwise water can infiltrate and damage sheathing or the back of siding. Replace the old board with a new one of the same size and shape. Pull siding away from house and cut through the bottom edge with aviation snips.

Once all the nails are removed from the adjoining board the damaged one should just pull out. Use tin snips to trim a piece of new siding to fit the lowest gap. Pull the nails holding the damaged siding and remove the damaged piece. When replacing siding try to purchase a piece from the same manufacturer in the same color.

The downside of replacing older vinyl siding is that it can be hard to match the style and color and siding rarely has any identifying marks. Check the instructions from your siding. The courses should overlap by at least 1 in. Attach the siding with 10d galvanized box nails driven into the overlap at least 1 2 in.

Remove all the damaged pieces of siding as well as the nails used to attach them. Most vinyl siding should overlap the pieces on either side of it by at least an inch. The damaged board or shake is the only part that must be replaced and the job goes fairly quickly. Be sure to nail into the existing holes on the adjacent siding.

Use framing square and utility knife to cut through face of siding. Cut piece of faded siding from an inconspicuous spot to replace the damaged section. When you replace the boards use a homemade reveal set jig to match the reveal of the existing siding.